Danaher Motion Kollmorgen
Driver Integration
5. 2
M
OTIONLINK
Install
MOTIONLINK
. Both software programs can be found on the website
(www.danahermotion.com) and the Product Support Package (PSP) CD-
ROM packaged with the drive. Follow the installation instructions.
MOTIONLINK
gives you three methods to configure the SERVO
STAR
SC.
The first uses a Startup Wizard that is the easiest and most highly
recommended approach. Its main purpose is for initial startups. The second
approach allows you to more indirectly perform the same configuration as
the first using the main
MOTIONLINK
screen. This method is most
convenient when corrections to an existing configuration are needed. The
third method uses the Terminal Mode screen to directly set (or monitor)
values for the same variables and commands the other two methods
configure through a friendlier user interface.
5.2.1.
STARTUP WIZARD
The MOTIONLINK Startup Wizard is accessed either directly through
MOTIONLINK or through MotionSuite once communication with the
controller is established following the steps outlined above. For more details
(including graphics), refer to the Installation manual.
NOTE
If you deactivate this screen, you can reactivate it by
going to the Main MOTIONLINK screen, pulling
down the Configuration menu, and selecting the
New Drive (123) option.
1.
Click Start. A dialog box is displayed describing the Drive Configuration
settings required.
2.
Read the entire text. When finished, click OK.
3.
Set the Bus Voltage.
4.
Verify the DIP switch settings and update if changes are made.
5.
Verify the serial number.
6.
Enable the axis.
7. Save.
8.
Click Close to return to the main Wizard screen.
9. Click
Next.
10. A dialog box displays describing the next screen. When you have
finished reading the contents, click OK.
11. Configure the motor. Verify all settings. Save any changes. Click Close
to return to the main Wizard screen.
NOTE
If the motor cannot be found in the database, click
on the User Define tab. Contact Danaher Customer
Support for detailed instructions.
12. Click
Next.
M-LN-016-0702 Rev D
05/07
21
Содержание Kollmorgen SERVOSTAR C Series
