![background image](http://html1.mh-extra.com/html/dallmeier/domera-ddz3018-im-hs/domera-ddz3018-im-hs_installation-and-configuration-manual_3347450078.webp)
www.dallmeier.com
78
DDZ30XX-YY/HS/IP
14.3.1.4 Motion Setup
The availability of the video motion detection function of the PTZ dome camera is depend-
ing on the built-in camera module (see chapter “
Technical Data
” on page 121).
The video motion detection function does not operate at IP based operation.
The motion detection starts operating after a stored preset with
Enable Motion
->
ON
is called.
When a motion occurs, the PTZ dome camera activates the set relay output and writes a
motion alarm to the alarm list, e.g.
ALARM: M001
for motion detection at preset
001
(see
section “
Alarm List
” on page 85).
Open the
Motion Setup
.
MOTION SETUP
Sensitivity : 11
Hold Time : 03SEC
Output : OFF
Position : ALL
Area Setup
Save and Exit
Sensitivity
Sensitivity (
1
–
16
)
Hold Time
03
–
99SEC
The
Hold Time
starts to count after a motion is detected.
Output
R01
: Relay out 1
R02
: Relay out 2
OFF
: No output
Position
Motion detection area
ALL
: Full screen
AREA
: Area defined in the
Area
Setup
(see below).
Select the
Sensitivity
.
Select the
Hold
Time
.
Select the
Output
which should be activated when a motion occurs.
Select the
Position
of the motion detection area.
If necessary, edit the motion detection area settings in the
Area Setup
(see below).
Execute
Save and Exit
.