DALBO AXR-H, Руководство пользователя

Страница: 21 / 50

AXR-H
Page 21
Hydraulic angle adjustment, roller (options) 2 50
Wheel bearings (see ”
Adjustments, wheel bear ings”
) 1 year
Lubricate the packer roller pivots daily until the grease begins to come out from be-
tween the plates. This will press impurities out of the plates.
Safety Instructions

It is extremely dangerous to work or walk under the AXR-H when it is raised in the
transport position unless it is securely blocked or held into position. The engine of
the tractor must be stopped and the brakes must be locked.

Defective hydraulic hoses must be replaced immediately. A ruptured hose could
cause personal injury to the user or mechanical damage to the equipment.

Inspect all nuts, bolts, hydraulic fittings or any other fastened assemblies often to
make sure that they remain thoroughly tightened.

In case skin should come in contact with oil or grease or in case clothing should
become stained with oil, remove the stained clothes immediately and wash the af-
fected skin areas thoroughly. Oil and grease are harmful to the skin.
Replaceable Wearing Parts
The discs and scrapers are classified as replaceable wearing parts, but the wear on
these parts is very limited. Changing of the replaceable parts is described under
”
Replacements and Repairs”
. To adjust the disc scrapers, see ”
Scrapers
” under ”
Ad-
justments and Settings
”.
Adjustments
Adjustment of the castle nuts on the side wing pivots
The pivots are tightened to a torque of 100 Nm by the factory, but they must be
tightened again if a gap develops between the plates.
The AXR-H must be completely lowered and unfolded before tightening the pivots.
1.
Knock the slotted split pin (A) out of the shaft.
2. Tighten the castle nut (A) to a torque of 100 Nm, or until there is no longer a
gap between the plates when the AXR-H is raised. Tighten the castle nut so that
the hole in the axle lines up with the notches of the castle nut. Remember to
insert the slotted split pin.