DALBO AXR-H, Руководство пользователя

Страница: 46 / 50

AXR-H
Page 46
4. Unscrew the castle nut (pos. 19).
5. Carefully knock off the hub (pos. 22) and remove the bearings.
6. Remove the seal (pos. 16).
7. Remove the outer ring from the bearing.
8. Clean all parts.
Fig. 40
Assembly
1.
Mount the outer ring from the bearings into the hub (pos. 22).
2. Place the seal (pos. 16) onto the axle.
3. Place the inner ring from the large bearing onto the axle and replace the hub.
4. Place the inner ring from the little bearing onto the axle.
5. Screw the castle nut onto the axle and turn the hub at the same time. Tighten
the nut until there is a slight drag on the wheel as it is turning. Next, loosen the
castle nut and back off until the split cotter pin is lined up with a hole in the ax-
le and also the castle nut. (If the wheel is still sluggish when it turns, loosen
the castle nut until the next hole in the axle is lined up with the nut.
6. Replace the split cotter pin.
7. Fill the hubcap ¾ full with grease and reinstall. For mounting of the wheel
(
see”
Dismounting/Mounting of Wheels
” ).