Daktronics FB-2700 Series, Руководство по установке, Страница: 32 / 60

Electrical Installation
28
Top Section
Middle Section
Bottom Section
(Power & Signal
Terminated
in this Section)
(Coiled Interconnect Cables
Located in this Section)
A2
Driver
A5
Driver
Power Panel
J52
P52
J51
P51
J50
P50
Figure 32: Power/Signal – TN-2650 & TN-2651
Four-Section Tennis Models
The primary driver and power panel will be located in the top section (Section A). Refer
to the component location drawings attached to the product specification sheets listed
in Appendix A for exact driver locations.
Open access panels as needed to locate the coiled bundles of interconnect cable,
then route and connect the cables as described below and shown in Figure 33 .
1� Route the interconnect cable labeled P50 coming from the A3 driver in Section B up
into Section A and connect it to the mating J50 jack coming from the power panel.
2� Route one end of the interconnect cable labeled P51 from Section B up into Section
A and connect it to the mating J51 jack coming from the power panel.
3� Route one end of the interconnect cable labeled P52 from Section B up into Section
A and connect it to the mating J52 jack coming from the power panel.
4� Route the interconnect cable labeled P51 coming from the A5 driver in Section C up
into Section B and connect it to the interconnect cable labeled J51 .
5� Route the interconnect cable labeled P52 in Section C up into Section B and
connect it to the interconnect cable labeled J52 .
6� Route the interconnect cable labeled P53 coming from the A7 driver in Section D up
into Section C and connect it to the interconnect cable labeled J53 .