Daktronics FB-2700 Series, Руководство по установке, Страница: 15 / 60

Mechanical Installation
11
Ad Panel Mounting
Use the mounting methods outlined in this section for static ad panels. These methods are
also used for ADPC and ADTI displays.
Note: Do not use lubrication on any mounting hardware or the warranty will be void!
Clamping Angles
Reference Drawings:
Ad Panel Mounting .............................................................................................. DWG-52187
Mounting hardware includes mounting channels; rear clamping angles; 1/2-13 x 15"
threaded rods; and 1/2" square nuts, hex nuts, and lock washers. Refer to Figure 12 and
DWG-52187 in Appendix B .
Note: The threaded rods do not pass through the beams; they run along both sides.
1� Position the ad panel at the front of the beams, and lift it to the desired height.
2� Using a clamping angle as a template, drill two 9/16" holes in the upper rear flange of
the ad panel cabinet where the mounting channel support will be placed.
3� Position a mounting channel inside the ad panel cabinet along the rear flange as
shown in Figure 12 .
4� Place 1/2" square nuts inside the mounting channel, and thread the rods through the
rear flange of the ad panel cabinet and the mounting channel.
5� Slide clamping angles over the other ends of both threaded rods, and then loosely
install the washers and nuts.
6� Make final adjustments to the ad panel position to ensure it is flush and level, and
firmly tighten all of the 1/2" hex nuts.
7� Repeat Steps 2–6 for every connection point to the beam. For example, if there are
two beams, there will be four connection points.
1/2" Hex Nut
1/2" Lock Washer
Clamping Angle
1/2" Square Nut 1/2-13 X 15" Threaded Rod
Beam
Ad Panel
Mounting
Channel
Figure 12: Ad Panel Clamping Angle Mounting, Side View