Daktronics FB-2700 Series, Руководство по установке, Страница: 18 / 60

Mechanical Installation
14
I-Beam Clamps (with LVX Displays)
Reference Drawings:
LVX Ad Panel I-beam Clamp Mounting ........................................................ DWG-3918326
Use this mounting method to mount an ad panel to I-beams with a flange thickness of
1/4" – 3/4". If flange is thicker than 3/4", longer bolts will be required at added expense.
Mounting hardware includes I-beam clamps, 1/2-13 x 3" bolts, 1/2" flat washers, and 1/2"
lock washers. Refer to Figure 15 and DWG-3918326 in Appendix B .
1� Position the ad panel at the front of the beams, and lift it to the desired height.
2� Slide a lock washer, flat washer, and I-beam clamp onto each bolt, and loosely
screw the bolts into the spring nuts. Position each of these I-beam clamp assemblies
as close to the I-beam flanges as possible.
3� Make final adjustments to the ad panel position to ensure it is flush and level, and
then firmly tighten all of the bolts.
Spring Nut
Ad Panel
with Unistrut
Beam
I-Beam Clamp
1/2" Flat Washer
1/2" Lock Washer
1/2-13 x3" Bolt
Figure 15: Ad Panel I-beam Clamp Mounting (LVX), Rear Rotated View