Daktronics FB-2700 Series, Руководство по установке, Страница: 12 / 60

Mechanical Installation
8
Clamping Angles
Reference Drawings:
P1647; Pole Mounting Options ........................................................................ DWG-1048184
Use this mounting method to mount a display to I-beams or any beam/pole that does
not have flanges. Mounting hardware includes spring nuts; rear clamping angles; 1/2-13
x 24" threaded rods; and 1/2" nuts, flat washers, and lock washers. Refer to Figure 8 and
DWG-1048184 in Appendix B .
Note: The threaded rods do not pass through the beams; they run along both sides.
1� Screw a threaded rod into each of the spring nuts as far as it will go.
2� Position a display section at the front of the beams with the threaded rods extending
from the rear of the spring nuts, straddling the beams.
3� Lift the display section to the desired height.
4� Slide clamping angles over both rods, and then loosely install the washers and nuts.
5� Make final adjustments to the display section position to ensure it is flush and level,
and then firmly tighten all of the 1/2" hex nuts.
6� Repeat Steps 1–5 for all display sections.
Mounting Tubes
Use this mounting method to mount a
display to horizontal beams. The mounting
tubes are attached to the cabinet using
spring nuts and 1/2" hardware; this may be
done during manufacturing or on site. Refer
to Figure 9 and DWG-1048268 for mounting
tube assembly. The clip angles can be
adjusted vertically before they are bolted or
welded to the horizontal beams. When using
this method, recommended attachment
method and positioning of display pieces
will be provided in site-specific diagrams .
1/2" Flat Washer,
Lock Washer, & Nut
Beam
Lower
Display
Section
Upper
Display
Section
1/2" Threaded Rod
Clamping Angles
at Rear of Beam
Spring Nuts
Figure 8: Clamping Angle Mounting, Side View
Display
Cabinet
Clip Angle
Mounting Tube
Horizontal
Beam
Figure 9: Mounting Tube Attachment, Side View