Dakota Digital RET, Инструкция по установке и эксплуатации

Страница: 23 / 25

650066 21
Symptom Possible Problem Solution
-----------------------------------------------------------------------------------------------------------------------------------
The fuel display reads
The control box may be set for Refer to “Fuel Setup”
backwards, incorrectly, the wrong type of fuel sender. section of the installation manual
or does not change. to ensure that the settings match
your fuel sender.
The fuel sender may not be Check the connections at both
connected to the control box ends of the fuel sender wire.
properly. Make sure the fuel sender is
grounded properly.
The fuel sender may not be Check the fuel sending unit with
operating properly. an electrical multi-meter.
The fuel sender may have a Use the custom fuel sender setup.
non-standard resistance See the Fuel Setup section of the
range. manual for instructions.
The oil or water display
The engine block may not be Use heavy ground cables from the
reading is incorrect. grounded to the chassis frame battery to the engine block.
or body properly. Make sure both ends of the cable
have clean metal-to-metal
connections.
Use a braided ground strap to
ground the engine block to the
chassis.
Use a large braided ground strap
to ground the engine block to
the body or fire wall.
The threads are not grounding to Make sure no thread sealant is used
the engine block. on any of the threads.
The sending unit wire is picking Isolate the sending unit wire from
up noise from nearby wires. motor and ignition wires.
The sending unit is not Use the sending unit provided
compatible with the control box the display system.
The sending unit has failed. Return the sending unit to
Dakota Digital for replacement.