Dakota Digital RET, Инструкция по установке и эксплуатации

Страница: 12 / 25

650066 10
SW 1 or Speed switch
The SW 1 terminal is used for selecting the various speed, distance, and performance
displays and also for entering the setup menu. The SW 1 input is activated by a ground
connection. The push button switch supplied (or any normally open switch) is wired by
connecting one terminal to SW 1 and the other terminal to a ground. When the button is
pressed and released, the speed message display will change. When the button is pressed and
held for a few seconds, any re-settable information displayed will be zeroed. On systems with
two message displays the one below the speed is dedicated to speed/performance messages.
On systems with one message display the speed/performance and rpm/warn messages will use
the same display.
SW 2 or Tach switch
The SW 2 terminal is used for selecting the various rpm, engine, and warning displays
and also for entering the demonstration mode. The SW 2 input is activated by a ground
connection. The push button switch supplied (or any normally open switch) is wired by
connecting one terminal to SW 2 and the other terminal to a ground. When the button is
pressed and released, the tach message display will change. When the button is pressed and
held for a few seconds, any re-settable information displayed will be zeroed. On systems with
two message displays the one below the tach is dedicated to rpm/warn messages. On systems
with one message display the speed/performance and rpm/warn messages will use the same
display.
To enter DEMO mode, press and hold the switch while turning the key on.
MESSAGE DISPLAYS
On systems with two message displays, switch 1 will toggle between the speed message
displays and switch 2 will toggle between the tach message displays.
On systems with one message displays, switch 1 will either switch from the tach
message to the speed message or toggle to the next speed message. Switch 2 will either
switch from the speed message to the tach message or toggle to the next tach message.
Speed message displays DESCRIPTION .
ODOMTR odometer mileage (0-999,999)
TRIP trip odometer mileage (0-999.9)
SERVIC miles since last service (0-9,999)
0-60 T 0-60 mph time in seconds (0-25.5)
HI SPD high speed recall (0-255)
QUARTR ¼ mile time in seconds (0-25.5)
QT MPH end of ¼ mile speed (0-255)
KPH xxx kph conversion (or mph conversion if metric)
Tach Message displays DESCRIPTION .
HI RPM high rpm recall (0-18,000)
RPM-WN rpm warning point (displays “SHIFT” when exceeded)
ENGINE check engine indicator
BRAKE brake warning indicator
4 WD 4 wheel drive indication
WAIT diesel wait to start indicator
GEAR gear shift position indicator
HOURS hours system has been on with tach signal (0-999.9)
BAR (on systems with no bar graph) bar tach readout on message display (0-8)
RPM (on systems with no digital tach) digital tach readout on message display
TACH (on systems with no digital tach) digital tach readout on speed display