Dake SE-912, Инструкция пользователя

Страница: 14 / 32

Dake Corporation
724 Robbins Road
Grand Haven, MI 49417
www.dakecorp.com
13 REV012019
CHANGING BLADE SPEED
Before changing the blade speed ensure that the saw is properly disconnected from its
power source
1) Loosen, but do not remove, the two 5/16” hex head screws under the motor pulley cover.
This allows the pulley to move slightly to readjust the belt for blade speed. Shown below.
2) Remove the motor pully cover and unclip the plastic fastener to open.
3) Using the “BLADE SPEEDS” section in the manual determine what blade speed is ideal
for the material being cut.
4) Using the chart on the inside of the cover determine what position to move the belt to get
the desired blade speed.
a. For standard 120V outlet use the 60Hz column.
b. Pulley orientation in illustration may differ slightly from actual saw. If chart displays
the belt in the top groves of the pulleys for a speed, then put the belt in the top
grooves, no matter the orientation of the pulleys.
5) After getting the belt in place, slide the motor left until the belt is taught, then tighten the
hex head screws securing the motor in place. Then close the pulley motor cover.