Dake SE-912, Инструкция пользователя

Страница: 11 / 32

Dake Corporation
724 Robbins Road
Grand Haven, MI 49417
www.dakecorp.com
10 REV012019
BLADE SPEED
Band speed recommendations presented on this chart are approximations and are to be used
as a starting point for most applications. For exact sawing parameters consult your blade
supplier. 120V outlets use 60 Hz columns.
Material
Speed (F.P.M.)
60 Hz 50 Hz
Tool, Stainless Alloy Steels,
Bearing Bronze, Cast-iron
Steel
105 85
Med. to High Carbon Steels,
Hard Brass or Bronze
196 164
Low to Med. Carbon Steel,
Soft Brass
288 240
Aluminum, Plastic 377 312
COOLANT
Use a water-soluble coolant.
Coolant is mixed 10:1, 10 parts water to one-part coolant. Once the coolant is mixed pour it into
the tray and let it run down into the reservoir. If a lot of coolant pools on one side of the tray the
saw may need to be leveled to let all the coolant drain from the tray equally and ensure all of the
coolant in the system is cycled when cutting.
OPERATION
VICE
Turning the handwheel (item 364) at the end of the bed will move the front jaw of the vice
forward and back. To tighten down a work piece insert it between the jaws and use the
handwheel to tighten the vice around the workpiece. Then lock the pressure knob of the vice by
pulling the handle (item 373 & 374) down into the locked position.