Dake SE-912, Инструкция пользователя

Страница: 12 / 32

Dake Corporation
724 Robbins Road
Grand Haven, MI 49417
www.dakecorp.com
11 REV012019
Vice adjustment for angled cuts:
Loosen the 3 hex head screws and the nut attached to the carriage bolt. Once loosened this will
allow both vice jaws rotate up to 45°. The carriage bolt may need to be loosened more to get to
bigger angles. Once each jaw is set to the same angle tighten all fasteners to secure vice in
place.
WORK STOP ADJUSTMENT
1) Loosen the thumb screw (item 48) holding the work stop casing (item 51) to the shaft.
2) Adjust the work stop casting to the desired length.
3) Rotate the work stop as close to the bottom of the cut as possible.
4) Tighten thumbscrew.
CONTROLS