Dake SE-912, Инструкция пользователя

Страница: 13 / 32

Dake Corporation
724 Robbins Road
Grand Haven, MI 49417
www.dakecorp.com
12 REV012019
CHANGING FEED RATE
Located on the front right of the saw is the adjustment for the feed rate as well as the down feed
lock. To slow the feed rate, turn the knob clockwise, counterclockwise causes the feed to
increase. Feed can be adjusted 0-10, 0 being no feed pressure causing the saw to fall the
fastest. At 10 the highest feed pressure, causing the saw to fall the slowest at this setting.
To lock the saw head in an elevated position, turn the handle so that it is perpendicular with the
feed cylinder. To unlock and resume down feed, turn the handle back parallel with the cylinder.
See figure below.
OPERATING
1) Raise saw head to partial vertical position and use the down feed lock to lock the head.
2) Open vice and insert the workpiece. Close vice securely around the workpiece.
a. If work piece is significantly long, support the end of the workpiece.
3) Lower the head of the saw until the blade is within a half an inch from the workpiece.
a. Starting the saw while it’s already running could damage the blade.
4) Set the down feed rate for the type of material that is being cut.
5) Turn the saw on and press the start button. Once the saw is up to full speed release the
head stop to let the saw gravity feed down into the workpiece.
a. Never force the saw into the work this could damage the saw as well as the work.
6) Once the saw has made the cut entirely, stop the saw or let the saw hit the limit switch.
7) Lift the head of the saw and loosen the vice to remove the workpiece.