Dake SE-912, Инструкция пользователя

Страница: 19 / 32

Dake Corporation
724 Robbins Road
Grand Haven, MI 49417
www.dakecorp.com
18 REV012019
SYMPTOM CAUSE SOLUTION
Motor running too hot
Blade tension is too high
Reduce tension on blade
Drive belt tension is too high
Reduce tension on drive belt
by loosening the two hex
head screws under the motor
pulley cover. Same screws
loosened in “CHANGING
BLADE SPEED” section of
the manual
Blade is too coarse for
material
Use a finer tooth blade
Blade is too fine for material
Use a coarser tooth blade
Gears alighted improperly
Adjust gears to that worm is
in the center of the gear
Gears need lubrication
Check oil path
Cut is binding the blade
Decrease feed pressure
Blade not cutting straight
Feed pressure is too high
Reduce feed pressure by
increasing the spring tension
on side of saw
Feed pressure is too low
Increase feed pressure by
decreasing the spring tension
on side of saw
Guide bearings not adjusted
properly
Adjust guide bearing,
clearance should be no
greater than .001”
Dull blade
Replace blade. See “BLADE
REMOVAL AND
INSTALLATION” section in
manual
Incorrect blade speed
Use chart inside pulley cover
and chart in the “BLADE
SPEED” section of the
manual to determine correct
blade speed
Blade guides are spaced too
far
Adjust blade guides. See
“BLADE GUIDE BEARING
ADJUSTMENT” section of
the manual
Blade guide assembly is
loose
Tighten blade guide
assembly
Blade tracks too far away
from wheel flanges
Re-track blade. See SET UP
section in manual