11
Recognition programming makes it possible for a product (remote control unit, detector, etc.) to be recognised by the control
panel. The control panel allocates a number to each product programmed for recognition in chronological order of
programming.
For products that need to be relayed, control panel recognition programming must be done via a radio repeater relay (see
Radio repeater relay installation manual).
3. Recognition programming
IMPORTANT
• To perform recognition programming operations, the control panel must be in installation mode.
• During recognition programming, the product to be programmed for recognition does not need to be close to the control
panel. In fact, it is advisable to move it at least 2 metres away from the control panel.
3.1 Programming a remote control unit to be recognised by the control panel
Press and hold
“Off”
(orange LED flashing)
until the control panel
responds
The control panel issues a voice
message and the remote control
unit LED lights up steady green
for 1.5 s to confirm recognition
)
)
)
)
)
10 s max.
then
“Bip, remote control unit X”
• Language
Depending on the user, you can replace the original system language, English, with a different language:
To select the language, programme:
Factory: English
• Setting the indication and speech synthesis volume
The level can be adjusted from 1 to 8.
Factory: average sound level = 4
Sound level from 1 to 8
2.7 Modifying the language and modifying the volume of indications
and speech synthesis system
0: French
1: Italian
2: German
3: Spanish
4: Dutch
5: English
“bip + chosen
language”
“bip + chosen level”
INSTALLA
TION
MODE
IMPORTANT: the control panel issues three
short beeps to indicate a programming error.
When this happens, perform recognition
programming again from the start.
7.
Connect the other end of the mains
cable to the mains power via an
unswitched fused connection box.
8.
Following power up, the control panel
will issue the voice message:
IMPORTANT
• If the control panel does not respond as it should:
- disconnect the mains power supply then disconnect the power module,
- disconnect the back-up battery,
- wait for 2 min,
- reconnect the back-up battery,
- reconnect the power module and then the mains power supply,
- check the control panel message.
• On power-up, the control panel is automatically in installation mode:
- if the battery is not detected, the control panel issues the voice message
“fault, accumulator voltage, control panel”
, and the red LED flashes until
the battery has been properly connected,
- if there is a mains power supply problem, the control-panel issues the
voice message
“fault, battery voltage, control panel”
,
- if using the Mains power supply (RX01X) and requiring to change the type
of power supply (BatLi22) this MUST be done totally UNPOWERED. It is
IMPERATIVE to disconnect the standby battery (Li-Ion 3.7 V/1.2 AH) and
wait for 2 minutes before re-connecting power.
To remove the module, press the
unlocking key and slide it downwards.
“bip, installation mode”
Press
*
then
#
on
the control panel
keypad