IM 1240-4 • INTELLIGENT EQUIPMENT 6
www.DaikinApplied.com
Installation
Retrofit Installation
DANGER
Electric shock hazard. Can cause personal injury or equipment
damage.
Prior to installing Intelligent Equipment hardware, power must be removed
from the unit. This means removing power at the breaker panel serving
the unit, and following proper lockout/tagout procedures at said breaker
panel for the duration of the install. Power should not be reapplied until all
electrical interconnections have been made and verified.
This equipment must be properly grounded. Connections and service to
the MicroTech II WMC Water-Cooled chiller, MicroTech III Air cooled Chiller
Controller, Packaged Rootop or Outdoor Air Handling unit, Machine-to-
Machine Gateway and Energy Management Module must be performed
only by personnel knowledgeable in the operation of the equipment being
controlled.
CAUTION
Static sensitive components. Can cause equipment damage.
Discharge any static electrical charge by touching the bare metal inside the
control panel before performing any service work. Never unplug cables,
circuit board terminal blocks, or power plugs while power is applied to the
panel.
WARNING
Sharp edges on sheet metal and fasteners can cause personal injury.
This equipment must be installed, operated, and serviced only by an
experienced installation company and fully trained personnel.
CAUTION
To avoid damaging wires or components, verify clearance in and around the
point of penetration prior to any drilling
During any drilling, ensure that resultant metal shavings are not allowed to
contact unit electronics.
Subsequent to any drilling, remove all resulting metal shavings from the
control enclosure.
NOTICE
For Cellular and Wi-Fi installations, do not power the M2M Gateway until
the antenna has been installed and connected.
NOTE:
The Intelligent Equipment retrofit installation should
take approximately one hour for a skilled HVAC
technician.
Содержание AGZ-D
Страница 45: ......
