Dahua Network Video Server
User’s Manual
55
4.4.2.13 Auto Register
From main window->Setup->Network->Register, the auto register interface is shown as
below. See Figure 4-56.
This function allows the device to auto register to the proxy you specified. In this way, you
can use the client-end to access the NVS and etc via the proxy. Here the proxy has a
switch function. In the network service, device supports the server address of IPv4 or
domain.
Please follow the steps listed below to use this function.
Please set proxy server address, port, and sub-device name at the device-end. Please
enable the auto register function, the device can auto register to the proxy server.
Figure 4-56
Please refer to the following sheet for detailed information.
Parameter
Function
Server
IP
address
The server IP address or server domain name you want to
register.
Port
The auto registration port value of the server.
Sub-device ID
The device ID allocated by the server.
4.4.2.14 Alarm Centre
From main window->Setup->Network->Alarm center, the alarm center interface is shown
as below. See Figure 4-57.
System can upload alarm signal to the alarm center when an alarm occurs.
Before you use alarm center, please set server IP, port and etc. When an alarm occurs,
system can send out data as the protocol defined, so the client-end can get the data.
