TBM
PILOT’S OPERATING HANDBOOK
850
SECTION 7
DESCRIPTION
Page 7.6.10
Edition 1 -- June 22, 2007
Rev. 0
ENGINE AIR INLET
Engine air inlet is located at front lower section of engine cowling. Air inlet port
is protected against icing by a hot air flux provided by engine. Air is driven
throughout a duct in engine casing before entering engine through a
protective screen. An inertial separator system inside the air duct protects the
engine from ingesting dense particles (water, ice, fine gravels, sand).
Separator consists of two movable vanes. During normal operation, air is
conducted directly towards engine air inlet. To separate particles suspended
in the air, vanes are positioned to force engine induction air to execute a
sharp turn : under the effect of centrifugal force denser particles separate
from the air and are discharged overboard through two apertures located
under engine cowling.
Operation of inertial separator vanes is electrically controlled by ”INERT
SEP” inverter located on ”DE--ICE SYSTEM” panel. When inverter is set to
ON, an electric actuator activates vanes ; ”INERT SEP ON” CAS message
lights on when vanes have reached their maximum deflection and remains
visible as long as switch remains ON. Full deflection takes about 30 seconds.
EXHAUST SYSTEM
Exhaust gases are evacuated through exhaust stubs located on sides of
engine cowlings.
ENGINE ACCESSORIES
All engine driven accessories [except power turbine tacho--generator (Np)
and propeller governor] are installed on accessory gearbox located
rearwards of engine.
Oil pump
Oil pump is a self--controlled gear pump located at the bottom of oil casing.
Fuel high pressure pump (HP)
Fuel high pressure pump is installed on accessory gearbox. It supplies fuel
nozzles, flow being controlled by fuel regulator (FCU). Fuel provided by
engine driven main pump (mechanical) enters high pressure pump through a
filter, then it is discharged under pressure into fuel regulator (FCU) through a
second filter. In case of contamination of this second filter, a by--pass valve
allows fuel to go directly from high pressure pump to the regulator.
PIM - DO NOT USE FOR FLIGHT OPERATIONS
Содержание TBM 850
