5
T
UNING IN NEW STATIONS
antenna position because the antenna will move according to the satellite position
and your position.
5
SEARCH OPTION
This unit includes common interface function. So you
cannot watch scrambled channels if you insert suitable
cam module and smart card. If you may not want to
search scrambled channels, you can skip the scrambled
channels by checking [FTA Only] options on Channel
Search option.
6
3-WAYS OF SEARCHING CHANNEL
If you choose [Search SAT], the receiver will search
channels from the selected satellite on current menu.
If you choose [Search Multi-SAT], the receiver will
search channels from the whole enabled satellite.
In case the satellite you want to receive is not on the sat-
list, you can manually search by choosing [TP search].
Before you do the [TP search], check the frequency and
symbol rate of the TP which you want to search channels
from. On [TP search] process all we need are just the frequency and symbol rate.
The satellite name is meaningless.
➠
21
Video RSatellite Receiver
5
T
UNING IN NEW STATIONS
Channel Search
1
Before you search the channels you must choose at least
one satellite and enable it. Press [MENU] and select
“Channel Search” with [SELECT].
2
Then choose the right LNB for the selected satellite.
3
In case you are using a dual LNB or two antennas
connected to a 22KHz tone switch, you can switch
between both LNB or antennas by pressing the [red
color] button of the remote control.
4
If you have installed Diseqc Motorized system, choose
the right one, move it to the right position following the
instructions below.
DISEQC 1.2 :
If you want to move the antenna to the west or east
position, press [left/right] button on your remote control
on ‘Position’ menu, until you see the yellow signal
strength bar. And set the position (press [OK] key). The
position will be stored. Then you can load the saved
antenna position after you changed the antenna position
on other satellite antenna position setting.
USALS :
If you have USALS system, you have to input your
position. And “send command” will move the antenna
to the correct position. You don’t have to save the
➠
20
Video RSatellite Receiver