DAELIM S2-250, Руководство по обслуживанию

Страница: 96 / 201

8-9
LH. CRANKCASE COVER/CONTINUOUSLY VARIABLE TRANSMISSION
●
Check the driven face assembly for wear or damage.
●
Measure the driven face O.D.
SERVICE LIMIT : 39.85mm replace if below
●
Check the movable driven face for wear or damage.
●
Measure the movable driven face I.D.
SERVICE LIMIT : 40.06mm replace if over
DRIVEN PULLEY FACE BEARING
REPLACEMENT
●
Remove the inner needle bearing out of the driven
pulley face.
●
Remove the snap ring and drive the outer bearing out
of the driven face.
●
Apply grease to the outer bearing.
●
Install a new outer bearing into the driven face with the
sealed end facing up.
●
Seat the snap ring in its groove.
●
Apply grease to the driven face bore areas (9~9.5g)
MOVABLE
DRIVEN FACE
DRIVEN FACE
GUIDE GROOVE