D-Link DGS-3324SRi Intelligent Stackable Gigabit Ethernet Switch
114
Figure 4- 74. Add/Modify OSPF Virtual Interface Setting
Configure the following parameters if you are adding or changing an
OSPF Virtual Interface
:
Parameter Description
Transit Area ID
Allows the entry of an OSPF Area ID
−
previously defined on the Switch
−
that allows a remote area to communicate with the backbone (area 0). A
Transit Area cannot be a Stub Area or a Backbone Area.
Neighbor Router
The OSPF router ID for the remote router. This is a 32-bit number in the
form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the remote
area’s Area Border Router.
Hello Interval (1-
65535)
Specify the interval between the transmission of OSPF Hello packets, in
seconds. Enter a value between 1 and 65535 seconds. The Hello
Interval, Dead Interval, Authorization Type, and Authorization Key should
have identical settings for all routers on the same network.
Dead Interval (1-
65535)
Specify the length of time between (receiving) Hello packets from a
neighbor router before the selected area declares that router down. Again,
all routers on the network should use the same setting.
Auth Type
If using authorization for OSPF routers, select the type being used. MD5
key authorization must be set up in the MD5 Key Settings menu.
Password/Auth. Key
ID
Enter a case-sensitive password for simple authorization or enter the MD5
key you set in the MD5 Key settings menu.
Transmit Delay
The number of seconds required to transmit a link state update over this
virtual link. Transit delay takes into account transmission and propagation
delays. This field is fixed at 1 second.
RetransInterval
The number of seconds between link state advertisement retransmissions
for adjacencies belonging to this virtual link. This field is fixed at 5 seconds.
