DES-6500 Chassis-based Layer 3 Ethernet Switch Manual
278
•
It is connected to the CS through the CS management VLAN.
3.
Candidate Switch (CaS)
- This is a switch that is ready to join a SIM group but is not yet a member of the SIM
group. The Candidate Switch may join the SIM group of the DES-6500 switch by manually configuring it to be a
MS of a SIM group. A switch configured as a CaS is not a member of a SIM group and will take on the following
characteristics:
•
It is not a CS or MS of another Single IP group.
•
It is connected to the CS through the CS management VLAN
The following rules also apply to the above roles:
•
Each device begins in a Commander state.
•
CS's must change their role to CaS and then to MS, to become a MS of a SIM group. Thus, the CS cannot
directly be converted to a MS.
•
The user can manually configure a CS to become a CaS.
A MS can become a CaS by:
•
Being configured as a CaS through the CS.
•
If report packets from the CS to the MS time out.
•
The user can manually configure a CaS to become a CS
•
The CaS can be configured through the CS to become a MS.
After configuring one switch to operate as the CS of a SIM group, additional DES-6500 switches may join the group by
manually configuring the Switch to be a MS. The CS will then serve as the in band entry point for access to the MS. The
CS's IP address will become the path to all MS's of the group and the CS's Administrator's password, and/or authentication
will control access to all MS's of the SIM group.
With SIM enabled, the applications in the CS will redirect the packet instead of executing the packets. The applications
will decode the packet from the administrator, modify some data, then send it to the MS. After execution, the CS may
receive a response packet from the MS, which it will encode and send it back to the administrator.
When a CS becomes a MS, it automatically becomes a member of the first SNMP community (include read/write and read
only) to which the CS belongs. However, if a MS has its own IP address, it can belong to SNMP communities to which
other switches in the group, including the CS, do not belong.
SIM Using the Web Interface
All DES-6500 switches are set as Candidate (CaS) switches as their factory default configuration and Single IP
Management will be disabled. To enable SIM for the Switch using the Web interface, go to the
Single IP Management
folder and click the
SIM Settings
link, revealing the following window.
Figure 11- 1. SIM Settings window (disabled)
Change the
SIM State
to
Enabled
using the pull down menu and click
Apply
. The screen will then refresh and the
SIM
Settings
window will look like this:
Содержание TM DES-6500
