DSL-2540T ADSL Router User Guide
25
2.
Under the
ATM VC Settings
at the top of the window should not be changed unless you have been instructed
to change them. However, if you are instructed to change the
VPI
or
VCI
values, type in the values assigned
for your account. Leave the
PVC
and
Virtual Circuit
setting at the default (
Pcv0
and
Enabled
) values for now.
This can be used later if you are configuring multiple virtual circuits for your ADSL service. For more
information on ATM VC Settings, see the table on page 39 below.
3.
Under the
Bridge Mode
heading, choose the
Connection Type
from the pull-down menu. This defines both
the connection type and encapsulation method used for your ADSL service. The available options are
1483
Bridged IP LLC
and
1483 Bridged IP VC-Mux.
If have not been provided specific information for the
Connection Type setting, leave the default setting.
4.
Most users will not need to change
ATM
settings. If this is the first time you are setting up the ADSL
connection it is recommended that you leave the
Service Category
settings at the default values until you have
established the connection. See the table on page 37 for a description of the parameters available for ATM
traffic shaping.
5.
When you are satisfied that all the WAN settings are configured correctly, click on the
Apply
button.
6.
The new settings must be saved and the Router must be restarted for the settings to go into effect. To save and
reboot the Router, click on the
Tools
directory tab and then click the
System
button. In the
System Settings
window, click the
Save and
Reboot
button under Save Settings and Reboot the System.
7.
Click
OK
when the following “Save and restart?” dialog box opens.
8.
The Router will save the new settings and restart. Upon restarting the Router will automatically establish the
WAN connection.
Settings for Bridge Mode connections:
Bridge Mode Parameters
Description
PVC
The Router supports using up to eight multiple virtual connections. This
window allows the user to configure WAN settings for all the available
connections (see instructions below on how to set up Multiple Virtual
Connections). Use the PVC drop-down menu to select the connection
(
Pvc0 to Pvc7) you want to configure. Since most users will use only a
single connection, the default setting
Pvc0 can be used for any changes
made to the WAN settings.
VPI
The Virtual Path Identifier is used with the VCI to define a dedicated
circuit on the ATM network portion of the connection to the Internet and
WAN. Most users will not need to change this setting.
VCI
The Virtual Channel Identifier is used with the VPI to define a dedicated
circuit on the ATM network portion of the connection to the Internet and
WAN. Most users will not need to change this setting.
Virtual Circuit
As with the PVC setting, this is mainly for use by clients who are
configuring the Router for multiple virtual connections. Use this to
Содержание DSL-2540T
