D-Link DSL-224, Руководство пользователя

Страница: 43 / 73

Section 3 – Web Configuration
41
Access Control List
Access Control List
Choose ADVANCED > Access Control List . The page shown as the figure
appears on the right. In this page, you can permit the data packets from LAN or
WAN to access the router in IPv4 protocol. You can configure the IP address for
Access Control List (ACL). If ACL is enabled, only the effective IP address in the
ACL can access the router.
Note:
If you select Enable in LAN ACL Switch, ensure that your host IP address
is in ACL list before it takes effect.
The following table describes the parameters and buttons of this page:
Field Description
ACL Mode

White List: permit certain types of data packets
from your local network or Internet network to the
Gateway.

Black List: block certain types of data packets
from your local network or Internet network to the
Gateway.
Direction Select Select the router interface. You can select
LAN or
WAN . In this example, LAN is selected.
LAN ACL Switch Select it to enable or disable ACL function.
IP Address
Enter the IP address of the specified interface. Only
the IP address that is in the same network segment
with the IP address of the specified interface can
access the router.
Services
Allowed
You can choose the following services from LAN:
Web , Telnet , SSH , FTP , TFTP , SNMP , or PING . You
can select
Any
to choose all the services.
Add
After setting the parameters, click it to add an entry to
the Current ACL Table .