D-Link DSL-224, Руководство пользователя

Страница: 12 / 73

Section 2 – Installation
D-Link DSL-224 User Manual
10
LED Color Status Description
DSL Green
Off No signal is being detected.
Blinking The device is handshaking with the physical layer of the office end.
On A connection is set up with the physical layer of the office end.
Internet
Green
Off The device is under the Bridge mode or powered off.
Blinking Internet data is being transmitted in the routing mode.
On The IP is connected.
Red On The device is attempted to become IP connected, but failed.
Figure 2 Rear panel
The following table describes the interfaces of the device.
Interface/Button Description
DSL
RJ-11 interface for connecting the host to the telephone jack on the wall or the MODEM interface of the
splitter through a telephone line.
LAN4/3/2/1
For a PC or other Ethernet-abled device to join the LAN of 224 by being connected to this interface with
RJ-45 cable.
WPS Press the button to enable or disable WPS function.
WIRELESS ON/OFF Press the button to enable or disable WLAN function.
ON/OFF Power switch, which is used to power on or power off the device.
12V DC IN (power) Interface for connecting the power adapter.
Reset (On the bottom side) Press and hold the button for 15~20 seconds to restore the factory defaults.