D-Link DSA-3600, Руководство пользователя

Страница: 90 / 204

Chapter 4. Web Interface Configuration
84
¾
New IP Address Assignment
: Service Zone is the service zone where APs are connected to. Start IP
Address is the start IP address that will be assigned to the discovered APs and it must be in the same
segment of the selected LAN interface.
¾
Admin Settings Used to Discover
: Select
Manual
, enter the current IP range of the APs in
IP Address
field if they are in default value. The IP of AP with factory default setting is “192.168.0.50.”. If the AP was
discovered before, the IP address of AP should have been changed. Please enter the right IP address of
the AP or reset the AP to default values.
Login ID
is the admin ID of the AP.
Password
is the password of
the AP. If the AP is in default value, just select
Factory Default
, system can discovery the APs.
The
Interface, Admin Settings Used to Discover
and
IP Addresses of APs after Discovery
configurations
are the same as the settings mentioned above. Check
Enable
to have more configuration. Select
Interva
l
setting from the drop-down menu to set the system to scan periodically according to this setting (the default
value is 10 minutes). If
Auto Adding AP to the list
is enabled, a new detected AP will be assigned an available
IP address from the IP address range set in
IP Addresses of APs after Discovery
and applied with the
selected template automatically.
y
Discovery Results
The discovered new APs will be listed here. The administrator can click
Add
button to register the APs to the
List
for management. When the system’s Service Zone is set to Tag-based mode, service zones also can be
assigned here. After clicking
Add
, the current management page is directed to AP List, where the newly added
APs will show up with a status of “configuring”. It may take a couple of minute to see the status of the newly
added AP to change from “configuring” to “online” or “offline”.