4 Web-based Switch Configuration
D-Link DGS-2000 Series Ethernet Switch User Manual
3
3
7
7
Figure 4.30 – System > SNMP Settings > SNMP Engine ID
System > SNMP Settings > SNMP Trap Settings
The SNMP Trap Settings page provide user to Specify whether the device can send SNMP notifications
.
Figure 4.31 – System > SNMP Settings > SNMP Trap Settings
Type
Description
SNMP Authentication Traps
Trap event of authentication failure.
System Coldstart Traps
Trap event of device cold boot up.
System Warmstart Traps
Trap event of device warn boot up.
Port Link Up / Link Down
Trap event of link state changes (link down/link up).
Firmware Upgrade State
Trap event of firmware upgrade status (success/failure).
Port Security Violation
Trap event of violations for port security.
Loopback Detection occuring /
recovery
Trap events of state changes (detected/recovery) for
loopback detection.
Duplicate IP Detected
Trap event when duplicate IP address detected.
Trap notification if PoE Power
On / Off
Trap event of PoE powering state in port basis.
Trap notification if PoE Power
Error
Trap event of PoE error.
Trap notification if over max
power budget
Trap event when device supplies power over the max
power budget.
Click
Apply
to make the configurations take effect.
System > User Accounts
The
User Accounts
page provides user to control user privileges. To add a new user by typing in a
User
Name
,
Password
and retype the same password in the
Confirm Password
and choose the level of
privilege (
Admin
,
Operator, o
r
User
) from the
Access Right
drop-down menu, then click the
Apply
button.
User can modify existing user account in the User Account Table. To change the password, type in the
Old
Password
,
New Password
and retype it in the Confirm New Password entry field and select the Encrypt,
then click the
Edit
button. To delete the user account, click on the
Delete
button.
Also, the
Password Encryption
mechanism offer encryption of account password in config file.
