Software Development
FM0+ S6E1C-Series Starter Kit Guide, Doc. # 002-10542 Rev. *C
38
Open the project file in Keil uVision IDE from the following directory on your PC:
Keil project:
<User_Directory>:
\
FM0+ S6E1C-Series Starter
Kit_Ver01
\Firmware\Demo Projects\s6e1c3_flash\ARM
\s6e1c3_flash.uvprojx.
Build the project and download the code to the S6E1C3 device.
Open the
Memory1
window from the
View
->
Memory Windows
. Enter
0x00017FF0 in the
Address
table and press the
Enter
key on your PC.
Run the program for a while (>10s).
Stop the program and check the content of 0x00017FF0 in flash.
4.2.4 UART Communication
4.2.4.1 Project Description
This project demonstrates the UART communication of the S6E1C3 device. This program
enables the MFS0 as UART mode to communicate with the CMSIS-DAP. The CMSIS-DAP
serves as the bridge between the MCU and PC.
4.2.4.2 Hardware Connection
No specific hardware connections are required for this project. All connections are hardwired on
the board.
Содержание FM0+ S6E1C-Series
Страница 48: ...FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 48 A Appendix A 1 Schematic Figure A 1 MCU...
Страница 49: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 49 Figure A 2 CMSIS DAP USB...
Страница 50: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 50 Figure A 3 Stereo Codec...
Страница 51: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 51 Figure A 4 Interfaces...
