Software Development
FM0+ S6E1C-Series Starter Kit Guide, Doc. # 002-10542 Rev. *C
39
4.2.4.3 Verify Output
1. Power the FM0+ S6E1C-Series Starter board from CN3 using USB cable, refer to
2. Open the project file in IAR Embedded Workbench or Keil uVision IDE from the following
directory:
IAR project:
<User_Directory>:
\
FM0+ S6E1C-Series Starter
Kit_Ver01
\Firmware\Demo Projects\s6e1c3_mfs_uart\IAR
\s6e1c3_mfs_uart.eww.
Keil project:
<User_Directory>:
\
FM0+ S6E1C-Series Starter
Kit_Ver01
\Firmware\Demo Projects\s6e1c3_mfs_uart\ARM
\s6e1c3_mfs_uart.uvprojx.
3. Build the project and download the code into S6E1C3 device.
4. Run the program.
5. Run the Serial Port Viewer, set the baud rate as
115200
, and click the
Disconnected
button
to connect the board with PC, as described in
Figure 4-3: Select the Baud Rate
6. Click the button shown below to toggle the Outgoing Data Window.
Figure 4-4: Toggle the Outgoing Data Window
Содержание FM0+ S6E1C-Series
Страница 48: ...FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 48 A Appendix A 1 Schematic Figure A 1 MCU...
Страница 49: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 49 Figure A 2 CMSIS DAP USB...
Страница 50: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 50 Figure A 3 Stereo Codec...
Страница 51: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 51 Figure A 4 Interfaces...
