Software Development
FM0+ S6E1C-Series Starter Kit Guide, Doc. # 002-10542 Rev. *C
36
Open the project in Keil uVision IDE
Power the FM0+ S6E1C-Series Starter board from CN3 using USB cable, refer
to
Open the project filein Keil uVision IDE from the following directory on your PC:
Keil project:
<User_Directory>:
\
FM0+ S6E1C-Series Starter
Kit_Ver01
\Firmware\Demo Projects\s6e1c3_dstc\ARM
\s6e1c3_dstc.uvprojx.
Build the project and download the code to the S6E1C3 device.
Open Watch1 window from
View
->
Watch Windows
.
Add the arrays
au32SourceData
and
au32DestinationData
in Watch1 window.
Run the program for a while (>10s).
Stop the program and check the arrays mentioned above. The Program
Counter (PC) will stop at the routine as below, which means the content of the
arrays are the same.
Содержание FM0+ S6E1C-Series
Страница 48: ...FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 48 A Appendix A 1 Schematic Figure A 1 MCU...
Страница 49: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 49 Figure A 2 CMSIS DAP USB...
Страница 50: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 50 Figure A 3 Stereo Codec...
Страница 51: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 51 Figure A 4 Interfaces...
