Getting Started with EZ-
PD™ CCG3
Document No. 002-00210 Rev. *A
4
Figure 2. CCG3 Design Flow
Select & Get CCG3 device
START
NO
Select Type-C Application
HARDWARE
DESIGN FLOW
APPLICATION
DEVELOPMENT
DESGN FLOW
Build reference schematic
based on application.
(Refer to CCG3 datasheet or
contact Cypress for reference
design schematics)
Do board design & build
prototypes for test & validation
Minor
Modifications?
Use EZ-PD
Configuration
Utility to make
updates to
Configuration
Table (eg: PDO
changes,
Vendor ID, etc)
Use EZ-PD
Configuration Utility to
update the modified
configuration table, or
program CCG3 device
Start with CCGx SDK.
Make application
specific modifications
to the source project.
Successfully build the
source project with
these modifications to
obtain firmware binary
files.
NO
YES
Perform Test & Validation.
Use CY4500 EZ-PD Protocol
Analyzer & EZ-PD Analyzer
Utility for Test & Debug phase.
Test & Validation
Complete?
YES
Stop
Start production & release
TEST &
VALIDATION FLOW
Get CY4531 CCG3
EVK OR use prototype
hardware
Review associated documentation,
reference designs and application notes
available on https://www.cypress.com/ccg3
