Getting Started with EZ-
PD™ CCG3
Document No. 002-00210 Rev. *A
2
USB Type-C support with PD
Integrated transceiver, supporting one Type-C port
Integrated upstream facing port
—UFP (R
D
), downstream facing port
—DFP (R
P
), and electronically marked
cable assembly
—EMCA (R
A
) termination resistors
Compliance with USB PD, supporting all standard power profiles
Integrated digital blocks
Four timers, counters, and pulse-width modulators (PWMs) and up to 20 general-purpose I/Os (GPIOs)
Four serial communication blocks (SCBs) for configurable master/slave I
2
C, SPI, or UART
Integrated USB Billboard controller with Billboard Device Class support
Integrated crypto engine with USB authentication support
Integrated analog blocks
20-V operation
Two V
BUS
gate drivers
2x2 Crossbar switch
1.2
CCG3 Block Diagram
shows a block diagram of the CCG3 architecture. For more details, refer to the
Figure 1
.
CCG3 Architecture Block Diagram
1.3
Prerequisites
This section lists the hardware and software required to get started with CCG3 devices.
