
22
Unicast:
This mode uses a discrete video stream between the
transmitter and every connected receiver and is ideal for simple,
point-to-point, streaming setups. This mode uses considerably more
bandwidth than Multicast mode when multiple receivers are being
used, however it does not require a network switch that supports
IGMP snooping.
6.6.4 Functions Tab
The Functions tab provides control over the transceiver’s AV source
management, streaming bandwidth/quality settings, and scaling, as well as
defining how USB and serial signals are handled. The available controls are
different depending on if the unit is in Transmitter Mode or Receiver Mode.
Changes made to these settings typically require a reboot of the unit. After
clicking on “Apply” please follow the reboot instructions in the WebGUI, if
necessary.
1) Video over IP (Transmitter Mode):
This section allows control over the
streaming bit rate and quality when in Transmitter Mode.
Source Selection:
Select the preferred input source, HDMI, or
DisplayPort.
Maximum Bit Rate:
Set the maximum bit rate that can be used by
the output video stream. Available options are: Unlimited, 400 Mbps,
200 Mbps, 100 Mbps, 50 Mbps. Selecting “Best Effort” will use up to
the maximum available bandwidth in order to maintain a full framerate
video stream.
Содержание CH-U331TR
Страница 1: ...CH U331TR UHD HDMI DP to IP AV over IP Transceiver Operation Manual Operation Manual ...
Страница 2: ......
Страница 59: ...54 ...
Страница 60: ...CYPRESS TECHNOLOGY CO LTD www cypress com tw ...