CYP CH-U331TR, Руководство по эксплуатации, Страница: 26 / 60

21
1) Channel Setup: Use the dropdown to select the broadcast or reception
channel for the transceiver. All receivers on the local network will receive
video and data content from the transmitter that set to the same channel.
The available channel range is from 0 to 255.
Note: Every transmitter within the same local network MUST be assigned
a different broadcast channel in order to avoid conflicts.
2) IP Setup: This section allows for configuration of the IP acquisition mode
and Ethernet settings of the unit. It also provides an easy way to find the
physical unit when installed with many other similar units.
„
IP Mode & Settings: The IP mode may be switched between “Auto
IP”, “DHCP” or “Static IP”. When the unit is set to Auto IP mode it
will automatically assign itself an APIPA address from the 169.254.
xxx.xxx range. When the unit is set to DHCP mode it will attempt to
automatically obtain an IP address from a DHCP server. When the IP
mode is set to static IP, you can manually set the IP address, netmask
and gateway address. Click the “Apply” button to save changes made
to the IP Mode or Configuration.
Note: The default network setting for this unit is “Auto IP”.
„
Find Your Device: Selecting “Show Me” will cause the unit to
immediately begin flashing the LEDs on the front of the unit to make
it easy to find. Selecting “Hide Me” returns the LEDs to their normal
behavior. This setting is useful when troubleshooting an installation
with a large number of units in a rack.
3) Casting Mode: Allows for the selection of the networking mode used by
the transceiver. Click the “Apply” button to save changes made to the
broadcasting mode.
Note: Receivers must be set to the same mode as the transmitter in
order to receive video and data content.
„
Multicast: This mode sends a single video stream that can be viewed
simultaneously by multiple receivers without increasing bandwidth
usage. This mode is ideal for video wall or matrixing scenarios.
Multicast mode requires a network switch with IGMP snooping
enabled.
Note: The 3 port network switch built into the dedicated receiver units
supports IGMP snooping and may be used to distribute a multicast
stream.