CynkoMet N-235 Series, Инструкция по использованию и эксплуатации

Страница: 55 / 124

Cynko Met
N-233
55
The soundness of bearings backlash has to be finally checked after driving a
few kilometers with the spreader, checking the degree of the hubs’ heating by
hand.
The following may be causes of significant resistance when turning wheels and
strong heating of hubs:
•
improper adjustment of bearing backlash,
•
contaminants found in grease,
•
damaged bearings,
The above symptoms require dismantling the wheel hub and removing the fault
(replacement of grease or bearings).
6.2 Brake adjustment.
Brake adjustment should be carried out if:
•
the brakes of both wheels do not brake uniformly.
•
expander levers are not parallel to each other,
•
a repair of the brake system was carried out.
Figure 10. Brakes regulation
1 – expander arm, 2 – expander roller, 3 - retaining ring (Seger), 4 - hand
brake cable, 5 – brake cylinder
With properly adjusted brakes, braking of both wheels must take
place at the same time.
Brake adjustment involves changing the position of the expander arm
5
4
3
1 2