CynkoMet N-221/3-3, Инструкция по использованию и эксплуатации

Страница: 68 / 119

Cynko Met N-221/3-3
N-221/4-3
68
8 – suspension spring pins, 9 - spring leafs, 10 – spring bearing plates, 11 –
expander dowels
Fig. 15. Lubrication points
1 – Support screw, 2 – Hand brake crank screw, 3 – Front socket wheels, 4 –
Tensioner pulley, 5 – Rear socket wheels, 6 – Wheel bearings, 7 – rocker axle,
8 – suspension spring pins, 9 - spring leafs, 10 – spring bearing plates, 11 –
expander dowels, 12 – bearings of the lower drum, 13 – bearings of the upper
drum
Before commencing the lubrication of the grease fitting, the greased
surfaces and places nearby lubrication points must be thoroughly cleaned of
mud and dust. The grease should be injected in the grease fitting until
release of fresh grease in the gaps between the mating parts.
6.9 Storage and maintenance.
After ending operation, the spreader must be carefully cleaned and
washed with a stream of water, and then left it in a dry and ventilated area. In
the event of failure of these actions on the zinc coating, dark and light gray
areas (spots) may occur, which do not constitute grounds for complaint if the
zinc coating still has the required minimum thickness (PN-EN ISO 1461: 2000).
3
1
2
5
4
6 8
9
7 10
11
12 13