CynkoMet N-221/3-3, Инструкция по использованию и эксплуатации

Страница: 64 / 119

Cynko Met N-221/3-3
N-221/4-3
64
replaced.
In the case of noting oiling on the body of the hydraulic cylinder, check
the nature of the leak. When fully taking out the cylinder actuator, check all
sealing places. Minor leaks with symptoms of "sweating" are acceptable, but if
you see a leak of a "drip" type, you must stop the spreader’s operation and
repair the failure.
CAUTION!
CAUTION!
The state of the hydraulic system should be controlled up to
date during its use. Using a spreader with a leaking hydraulic
system is unacceptable.
6.5 Adapter support
Use of the adapter is based on controlling the current state of the
elements cooperating directly with the spread material (knives, scattering
strips), and used to cover the drums adapter (guards)
6.6 Operation of the floor conveyor
The work associated with operating the conveyor consists of checking the
technical conditions: front and rear socket wheels, the state of the chain,
tearing points and bearing elements of the conveyor. Check that the socket
wheels are not damaged, cracked. Check that the scrapers mounted on the
back beam are not damaged, if the bolts that secure them are not loose.
Checking the condition of the chain to see if it is not extended is
based on lifting it in the middle part of its length from the top side (on the
floor panel) to the top. Is this amount not too large and does not exceed 50
mm. If this height does not exceed 50 mm and the tensioner is able to move
forward (gut of the tensioner), adjust the chain tension by screwing the nut
on the tensioner.
In the case of exceeding the height by 50 mm and lack of space for
the possibility of tensioning the chain with a tensioner, it is advisable to
shorten the conveyor chain by 2 links.