CynkoMet N-221/3-3, Инструкция по использованию и эксплуатации

Страница: 42 / 119

Cynko Met N-221/3-3
N-221/4-3
42
tractor comply with the requirements of the Manufacturer of the spreader
and the tractor.
In order to connect the spreader to the tractor, perform the following
steps:

Prior to coupling the spreader with the tractor, check if the spreader is braked
with the parking brake.

Set the drawbar hitch anchorage on the height of the transport hitch of the
tractor (this can be achieved by adjusting the drawbar spring tension).

Reversing the tractor, connect the drawbar end with the upper transport
hitch of the tractor (if in the agricultural tractor, an automatic coupler is used,
ensure that the aggregate operation has been completed correctly and the
drawbar anchorage is secured).

Stop the tractor engine and remove the key from the ignition.

Install and secure the hitch swivel from falling out or check the hook clasp
automatically.

Connect with the electric, hydraulic and brake installation wiring with the
trailer.
 Release the parking brake of the machine.
CAUTION!
CAUTION!
At the time of the coupling, unauthorized people cannot be
between the spreader and the tractor. The operator of the
tractor, when connecting the machine should be particularly
careful when working and make sure that in the course of
coupling, other people are not in the danger zone.
When connecting the hydraulic hoses to the tractor, pay
attention that the hydraulic system of the tractor and the
spreader are not under pressure.
When coupling ensure adequate visibility. If the case of
restricting visibility, use the sound signal from the tractor or use
the help of another person.
Connecting the spreader with another transport hitch is
unacceptable because it threatens the safety of road traffic and