CynkoMet N-221/3-3, Инструкция по использованию и эксплуатации

Страница: 17 / 119

Cynko Met N-221/3-3
N-221/4-3
17

Before driving, make sure that the spreader is properly connected to the
tractor (in particular, check the link pin hook).

It is forbidden to park on the slopes with a loaded and unsecured machine.
Securing is based on stopping with the service brake, parking brake and
planting chocks under the wheels. The chocks (1) should be planted only
under one wheel (2) (one front wheel and one on the back - Fig. 3).
Figure 3. The way of placing the chocks.

Prior to each spreader's use, check its technical condition, especially in terms
of safety. In particular, check the technical condition of the coupling system,
drive system, brakes and signaling lights and hydraulic, pneumatic and
electrical connection elements.

Before driving, check that the parking brake is released and the braking force
regulator is set to the correct position (concerns pneumatic systems with a
manual, three-position regulation).

The spreader is adapted for driving on slopes up to 8°. Moving the spreader
on an area with steeper slopes may cause the spreader to tip over as a result
of loss of stability.

Each time, after finished work, drain the air reservoir in the pneumatic
installation. During frosts, freezing water may cause damage to pneumatic
system components.

It is prohibited to exceed the admissible spreader load. Exceeding the
carrying capacity may lead to equipment damage, loss of stability while
driving, scattering of the load and cause a hazard to third parties during
1
2