CYBELEC CybTouch 12PS, Руководство пользователя

Страница: 20 / 64

User Manual – CybTouch series
CybTouch Series – User Manual
J
AN
.
2020
V5.0
19/63
This parameter allows defining the counting mode of the part counter. When set to up , the
counter will count up to the desired number. When set to down , the counter will count
from the desired number down to 0.
The counter stops the cycle when total is reached.
The value of the counter is automatically memorized when the numerical
control is shut down.
This function allows choosing the data entry mode for the back gauge on the Bend
Numerical Page or EasyBend Page. When set to
yes , the length of the flange icon is
displayed by default. When set to no, the icon for the position in mm of the back gauge
is displayed.
When set to
never , the position of the back gauge is no longer linked to the bending
angle, i.e. the position is never recalculated when the bending angle is modified.
The default value for this preference is never . Note that completely formatting
the machine will reset this preference to its default value.
The
mode is not available for graphical parts (see also Set point back
gauge (X axis) / flange length ).
This parameter controls the recalculation of the axes position values when a part
is loaded. It is useful when there is a possibility that something has changed, like
dimensions of tools or back gauge, since the last time the program was run.
The default value for this parameter is
no .
Corrections remain the same. We emphasize again the good practice of using
corrections (see
Bending and Corrections ) to fine tune a program. In
this case, even if modifications have happened, the part will be recalculated and
properly bent.
Program counter
mode
Show L first
Disable
recalculation at
product load