19
3.5.5 Notification Appliance Circuits (TB1 Terminals 1-4 on receiver card)
The CP-3000 control panel provides a special application notification appliance circuit which is field
selectable for either 1 Class A Style Z or 2 Class B Style Y supervised power limited outputs. Output
voltage is also field selectable between 12 and 24 Volts D.C. The Class and voltage are determined
by the settings of SW3 and SW4 on the receiver card. The NAC circuit connector is labeled TB1 and
located on the lower right edge of the receiver card. The CP-3000 will maintain the NAC circuit output
voltage at either 12 or 24 volts even if the battery voltage drops below 12 or 24 volts. The NAC
circuits are also software site specific programmable for activation and deactivation. Refer to the
programming section for complete activation and deactivation programming options. The circuits
utilize current sensing technology and if the rated current draw is exceeded, the NAC circuit will
deactivate. It will attempt to reactivate only if another device sends an alarm or the NAC circuit is
reset by the control panel and then reactivated by another alarm. In class B operation, an end of line
resistor P/N TR-3 must be placed at the last appliance connected to the circuit or a trouble will be
transmitted to the control panel. A trouble will also be sent if a ground fault exists on a NAC circuit.
Figure 7 shows proper wiring of NAC circuit. Table 1 shows compatible notification appliances.
Synchronization is achieved by using one of the compatible synchronization modules.
Output ratings:
Class B – 2 output circuits
12 Volts D.C. @ 2 Amps or 24 Volts D.C. @ 1 Amp each
Class A – 1 output circuit
12 Volts D.C. @ 2 Amps or 24 Volts D.C. @ 2 Amps
3.5.6 Notification Appliance Compatibility
The following UL Listed notification appliances are compatible with the CP-3000
Control Panel
MANUFACTURER
MODEL NUMBER
TYPE
SW4 SETTING
WHEELOCK
AS-121575W
HORN/STROBE
12 Volts
WHEELOCK
HS4-121575W-FR
HORN/STROBE
12 Volts
WHEELOCK
MT-12/24-R OR –W
HORN
12 or 24 Volts
WHEELOCK
MT-121575W-FR OR –NW
HORN/STROBE
12 Volts
WHEELOCK
MT4-12/24-R OR –W
HORN
12 or 24 Volts
WHEELOCK
AMT-12/24-R OR –W
HORN
12 or 24 Volts
WHEELOCK
RSS-121575W-FR OR –FW
STROBE
12 Volts
WHEELOCK
RSSP-121575W-FR
STROBE
12 Volts
WHEELOCK
SM-12/24-R
SYNC MODULE
12 or 24 Volts
WHEELOCK
DSM-12/24-R
SYNC MODULE
12 or 24 Volts
GENTEX
GEH12-R OR –W
HORN
12 Volts
GENTEX
GES3-12 SERIES
STROBE
12 Volts
GENTEX
GEC3-12 SERIES
HORN/STROBE
12 Volts
GENTEX
AVSM-R OR –W
SYNC MODULE
12 Volts
SYSTEM SENSOR
H12/24 SERIES
HORN
12 or 24 Volts
SYSTEM SENSOR
PA400 SERIES
HORN
12 Volts
SYSTEM SENSOR
S1224MC SERIES
HORN
12 or 24 Volts
SYSTEM SENSOR
P1224MC SERIES
HORN/STROBE
12 or 24 Volts
SYSTEM SENSOR
MDL
SYNC MODULE
12 or 24 Volts
