22
Maintenance
EN
–
–
Battery voltage
If you turn the ignition key to the position, the
battery voltage is briefly shown and then the total
operating hours.
Î
Charge the battery as quickly as possible.
Î
It may be necessary to have the charging system
checked by a service centre for possible damage.
–
–
–
Air filter mainte
-
nance
Î
Perform air filter maintenance immediately (see
engine operating manual).
This indicator appears every 25 operating hours for
a period of 7 minutes.
Maintenance
WARNING !
Risk of injury or property damage
¾
Only perform maintenance and cleaning
work on the device with the engine at a
standstill.
¾
Remove the ignition key and the spark-
plug connectors.
¾
Wait until all moving parts have come
to a complete stop and the engine has
cooled down.
¾
Never reach into the rotating cutter
blades.
¾
Only have repair and maintenance
work and the replacement of safety
components performed by a qualified
specialist or a specialist service centre.
¾
Only have the cutter blades replaced
or re-sharpened by a specialist service
centre.
¾
Clean the device and all add-on and
accessory parts after every instance of
use.
Cleaning the device
Attention !
¾
Do
not
use high-pressure cleaners for cleaning
the device.
Î
Park the mower on firm and level ground.
Î
Switch the parking brake on.
Î
Clean the device with a scrubbing brush, hand
brush or a cloth.
Cleaning the cutter deck
DANGER !
Sharp, moving cutting tools
Â
Risk of injury
¾
Wear protective gloves.
¾
Caution when cleaning the cutters.
¾
Note that the movement of one cutting
tool may lead to the rotation of other
cutting tools.
Attention !
Fuel may run into the combustion chamber.
Â
Damage to engine
¾
The mower must not be tilted to an angle greater
than 30°.
Î
Bring the cutter deck to the top position.
Î
Clean the cutting chamber with a scrubbing brush,
hand brush or a cloth.
Cutters with cleaning nozzle (optional)
T
Cleaning
Î
Park the device on a clean and firm foundation.
Î
Switch the parking brake on.
Î
Use a commercially available quick-release cou-
pling to attach a water hose.
Î
Start the engine.
Î
Lower the cutter deck and switch it on.
Î
Allow the engine and cutter deck to run for a few
minutes.
Î
Switch the engine and cutter deck off.
Note
If available, repeat the steps for the second
cleaning nozzle.
Drying
Î
Bring the cutter deck to the top position.
Î
Start the engine and switch the cutter deck on.
Î
To dry the cutter deck, allow the engine and cutter
deck to run for a few minutes.
Î
Switch the engine and cutter deck off.
Содержание 17CIDGHB603
