CTS MCT-RACK-12-MGM, Руководство пользователя

Страница: 20 / 103

20
Power (A-B): Display the status of powers.
2. Display or verify currently-configured settings
Refer to the following sub-sections for more information.
2.6 Configuration Mode
When you enter “configure” or “config” and press “Enter” in Privileged Mode, you will be
directed to Global Configuration Mode where you can set up advanced functions,. Any
command entered will be applied to running-
configuration and the device’s operation. From
this level, you can also enter different sub-configuration modes to set up specific
configurations.
Command Description
chassis Enable or disable power supply for installed media converters.
exit Exit the Configuration Mode.
help Display a list of available commands in Configuration Mode.
history Show commands that have been used.
ip Set up the IP address.
management Set up the system service type.
ntp Set up required configurations for Network Time Protocol.
snmp-server Create a new SNMP community and trap destination and specify the trap types.
switch-info Specify company name, host name, system location, etc.
syslog Enable or disable syslog server and assign server IP address.
user Create a new user account.
no Disable a command or set it back to its default setting.
slot Set up media converter configuration.
show Show a list of commands or show the current setting of each listed command.
2.6.1 No Command
Most commands that you enter in Configuration mode can be negated using “no” command
followed by the same or original command. The purpose of “no” command is to disable a
function, remove a command, or set the setting back to the default value. In each sub-
section below, the use of no command to fulfill different purposes will be introduced.
2.6.2 Show Command
The command “show” is very important for network administrators to get information about
the device, receive outputs to verify a command’s configurations or troubleshoot a network
configuration error. “Show” command can be used in Privileged or Configuration mode. The
following describes different uses of “show” command.
2.6.3 Chassis Command
This is to enable or disable power supply on a corresponding slot.
Command Parameter Description
MCT-RACK(config)# chassis power
[slot_list] [slot_list] Enable power supply on
specified slots.