45
Switch(config)# loop-detection unlock-interval 120
Set the Loop Detection unlock time
interval to 120 minutes.
Switch(config)# loop-detection vlan-id 100
Set the Loop Detection VLAN ID to
100.
Use “Interface” command to configure a group of ports’ Loop Detection settings.
Dot1x & Interface command
Parameter
Description
Switch(config)# interface [port_list]
[port_list]
Enter several discontinuous port
numbers separated by commas or a
range of ports with a hyphen. For
example:1,3 or 2-4
Switch(config-if-PORT-PORT)#
loop-detection
Enable Loop Detection function on the
specific ports.
No command
Switch(config)# interface [port_list]
[port_list]
Enter several discontinuous port
numbers separated by commas or a
range of ports with a hyphen. For
example:1,3 or 2-4
Switch(config-if-PORT-PORT)# no
loop-detection
Disable Loop Detection function on
the specific ports.
2.6.11 MAC Command
Set up MAC address table aging time. Entries in the MAC address table containing source MAC
addresses and their associated ports will be deleted if they are not accessed within aging time.
MAC Command
Parameter Description
Switch(config)# mac address-
table aging-time [0, 10-77925]
[0, 10-
77925]
Enter the aging time for MAC addresses in
seconds. 0= never aging out.
No command
Switch(config)# no mac
address-table aging-time
Set MAC address table aging time to the
default value (300 seconds).
Show command
Switch(config)# show mac
address-table
Show MAC addresses learned by the
Managed Switch
Switch(config)# show mac
address-table clear
Clear MAC address table.
Switch(config)# show mac
address-table interface
[port_list]
[port_list]
Show MAC addresses learned by the
specified interfaces.
Switch(config)# show mac
learning
Show MAC learning setting of each
interface.
Switch(config)# show mac
static-mac
Show static MAC address table.
Switch(config)#show mac
aging-time
Show current MAC address table aging
time or verify configured aging time.
MAC command example
Switch(config)#mac address-table aging-time Set MAC address aging time to 200
Содержание FOS-3148 Series
Страница 108: ...108 This sets up each port s path cost The default value is 0...
Страница 182: ...182 Restart DHCP service...
