23
Serial Number:
Display the serial number of this Managed Switch.
Date Code:
Display the Managed Switch Firmware date code.
Up Time:
Display the up time since last restarting.
Local Time:
Display local time.
Current Run In:
Display the current running firmware image.
Reboot Run To:
Display the firmware image which will run after next restarting.
Case Fan (1-6):
Display the status of case fans.
Power (A-B):
Display the status of powers.
Battery State:
Display the status of battery (For BAT version only).
2. Display or verify currently-configured settings
Refer to the following sub-sections.
“Interface command”, “IP command”, “MAC command”, “QoS
command
”, “Security command”, “SNMP-Server command”, “User command”, “VLAN command”
sections, etc.
3. Display interface information or statistics
Refer to
“Show interface statistics command” and “Show sfp information command” sections.
4. Show default, running and startup configurations
Refer to
“show default-setting copmmand”, “show running-config command” and “show start-up-
config command
” sections.
2.6 Configuration Mode
When you enter
“configure” or “config” and press “Enter” in Privileged mode, you will be directed to
Global Configuration mode where you can set up advanced switching functions, such as QoS,
VLAN and storm control security globally. All commands entered will apply to running-configuration
and the device
’s operation. From this level, you can also enter different sub-configuration modes
to set up specific configurations for VLAN, QoS, security or interfaces.
Command
Description
acl
Set up access control entries and lists.
channel-group
Configure static link aggregation groups or enable LACP function.
dot1x
IEEE 802.1X global configuration commands
exit
Exit the configuration mode.
help
Display a list of available commands in Configuration mode.
history
Show commands that have been used.
ip
Set up the IPv4 address and enable DHCP mode & IGMP snooping.
Ipv6
To enable ipv6 function and set up IP address
lldp
LLDP global configuration mode
loop-detection
Configure loop-detection to prevent loop between switch ports by locking them.
mac
Set up MAC learning function of each port
management
Set up console/telnet/web/SSH access control and timeout value.
mirror
Set up target port for mirroring.
ntp
Set up required configurations for Network Time Protocol.
qos
Set up the priority of packets within the Managed Switch.
Содержание FOS-3148 Series
Страница 108: ...108 This sets up each port s path cost The default value is 0...
Страница 182: ...182 Restart DHCP service...
