CTE ZED 23.2 JH, Руководство по эксплуатации и обслуживанию, Страница: 34 / 56

Use and maintenance manual
ZED 23.2 JH
Code n°UM0260_GB
32
•
insert the handle into the manual pump, (
pos. 1 fig. 4.4.2
) located near to the rear
outrigger
•
activate the manual pump, while the operator in the basket activates the desired
movement control.
When the platform has been recovered, return the manual pump control lever to the
original position and fix it to the turret using the black blocking knob.
4.4.5 Manual platform recovery from the ground
In case of malfunctioning in the vehicle engine or the gear pump that provides driving
power to the whole equipment, or power-cut, the basket can be returned as follows:
•
remove the manual pump control lever fixed in the turret, by loosening the black
blocking knob
•
insert the handle into the manual pump
•
remove the lead seal from the (
pos. 1 fig. 4.4.3
) “outriggers/basket control” diverter
valve positioned near to the outrigger controls
•
remove the cover from the valves block in the turret
•
carry out the recovery following the indications on the sticker positioned on the lid
(
fig. 4.4.4
).
When the recovery has been made, restore as follows:
•
loosen the knobs fully relative to the manoeuvres performed
•
loosen knob "P" fully
•
loosen the right knob fully (basket side) of the diverter valve
ATTENTION:
contact the After-sales Centre to check and repair the fault and apply a new
thread with seals on the previously lead sealed valves.
•
re-position the control lever in the turret and fix it to the turret using the black
blocking knob.
1
fig. 4.4.2
1 fig. 4.4.3
fig. 4.4.4