CTE ZED 23.2 JH, Руководство по эксплуатации и обслуживанию, Страница: 31 / 56

Use and maintenance manual
ZED 23.2 JH
Code n°UM0260_GB
29
4.3.4 Putting the elevated work platform into rest conditions
Take the work platform into the rest position by making the following manoeuvres:
•
turn the work platform until it is in the central position (at 90° with respect to the
yellow boom LED on
pos.1 fig. 4.3.7
)
•
make the extension retract completely, position the turret in the centre making the
yellow signs coincide, lower the telescopic boom, close the jib, close the
pantograph until reaching the rest position. At this point, a buzzer sounds. Keep
acting on the control until the buzzer switches off and the manoeuvre stops
automatically (6 seconds).
•
check that the jib is positioned on the support
•
descend from the work platform carefully
•
insert the key into the ground control selector switch (
pos. 1 fig. 4.3.6
) and turn it to
the “outriggers” position (
pos. 3 fig. 4.3.6
)
•
make the outriggers retract to end run, activating the levers alternately (
pos. 1-2-3-4
fig. 4.3.4
)
•
check that the outrigger yellow LEDs switch off (
pos. 3 fig. 4.3.6
)
•
turn the key to the "neutral" position and extract it from the selector switch (
pos. 1 fig.
4.3.6
).
ATTENTION: turn the platform in closing position (yellow led activated)
before you put it on rest position. In case of wrong position, the
system activate an alarm and the the closing operation are blocked.
!
NOTE:
The picture shows the correct closing and rest position of the
arm