CTE ZED 23.2 JH, Руководство по эксплуатации и обслуживанию, Страница: 28 / 56

Use and maintenance manual
ZED 23.2 JH
Code n°UM0260_GB
26
4.3.2 Stabilisation of the elevated work platform (EWP)
Start the vehicle engine as follows:
•
climb into the driver's seat of the vehicle
•
block the vehicle using the parking brake and position the gear lever in neutral
•
start the engine according to that indicated in the vehicle instructions
•
if the vehicle is equipped with an automatic device that increases the revs.
accelerate the engine slightly
ATTENTION:
never exceed 1000 rpm of the motor.
The motor could overheat and the pump could break.
•
insertion of the PTO:
−
press the clutch pedal fully home
−
activate the control lever positioned between the seats (
fig. 4.3.1
) in the
“ENGAGEMENT” position, the power take-off LED switches on (
pos. 1 fig. 4.3.2
)
and an acoustic signal is activated
−
if the truck has a electro-magnetic joint, via switch (see truck instructions
manual) when engagement has taken place, a visual and acoustic signal are
activated
−
release the clutch pedal slowly.
fig. 4.3.1
fig. 4.3.2
Go to the "Ground control board" positioned at the side of the truck:
•
insert the key into the selector switch (
pos. 1 fig. 4.3.3
) and turn to the “Outrigger
controls” position (
pos. 3 fig. 4.3.3
)
•
the “voltage presence” LED switched on (
pos. 2 fig. 4.3.3
)
•
check that all of the outrigger indicators are off: if this is not the case, it means that
there is a malfunction in the outriggers end runs.
1 2
fig. 4.3.3
2
3
1