Chapter 4. Web Configuration & Operation
321
CHAPTER 4
WEB OPERATION & CONFIGURATION
QCE Configuration
Port Members:
Select ports that use this rule.
Key Parameters
SMAC:
Select source MAC address type. By default, any is used. Select “Specific” to specify a source MAC (first three
bytes of the MAC address or OUI).
DMAC Type:
Select destination MAC address type. By default, any is used. Other options available are “UC” for unicast,
“MC” for multicast, and “BC” for broadcast.
Tag:
Select VLAN tag type (Tag or Untag). By default, any type is used.
VID:
Select VID preference. By default, any VID is used. Select “Specific”, if you would like to designate a VID to this
QCL entry. Or Select “Range”, if you would like to map a range of VIDs to this QCL entry.
PCP:
Select a PCP value (either specific value or a range of values are provided). By default, any is used.
DEI:
Select a DEI value. By default, any is used.
Frame Type:
The frame types can be selected are listed below.
Any:
By default, any is used which means that all types of frames are allowed.
Ethernet:
This option can only be used to filter Ethernet II formatted packets (Options: Any, Specific – 600-ffff hex;
Default: ffff). Note that 800 (IPv4) and 86DD (IPv6) are excluded. A detailed listing of Ethernet protocol types can
be found in RFC 1060. A few of the more common types include 0800 (IP), 0806 (ARP), 8137 (IPX).
LLC:
LLC refers to Link Logical Control and further provides three options.
SSAP:
SSAP stands for Source Service Access Point address. By default, any is used. Select specific to indicate
a value (0x00 - 0xFF).
DSAP:
DSAP stands for Destination Service Access Point address. By default, any is used. Select specific to
indicate a value (0x00 to 0xFF).
Содержание MSW-4424C Series
Страница 1: ...1 MSW 4424C MSW 4424CS L2 Gigabit Carrier Ethernet Switch ...
Страница 382: ......
